Fixed on the first visit
Common parts are on the van, so most tap jobs don’t need a second trip.
Taps & Mixers in St Albans
Dripping, stiff or running cold? Repaired or replaced, usually within a single visit. Covering St Albans and the surrounding Hertfordshire area, quoted up front and tidied up afterwards.
What the job involves
Taps are the job we’re called out for most. A drip that’s got worse, a handle that’s gone stiff, or one side running cold when it shouldn’t. Sometimes it’s a cartridge or a washer. Sometimes the tap itself is past repair, and replacing the unit works out cheaper than persevering with it.
We carry common cartridges, washers and flexi connectors, so a lot of tap work gets finished on the first visit. If a new tap is the sensible answer we’ll tell you what will fit your basin or sink before you go and buy anything.
Kitchen mixers, basin pillar taps, bath and shower mixers, outside taps, all the same day-to-day work. Tap replacement in Harpenden or St Albans is usually an hour or less.
What’s included
- Drip and cartridge diagnosis
- Washer, cartridge and headwork replacement
- Full tap and mixer swaps
- New flexi tails and isolation valves
- Seized-tap removal on older installs
- Old unit taken away
A free, fixed quote before any work starts.
Every taps & mixers job is different, so yours is priced on its own rather than from a list. Tell us what is happening, send a photo if you have one, and you will get one figure for the whole job. It does not change once we start, and nothing is added at the end.
How the job runs, from the first call to the finish.
01
You call us
You speak to us directly. Describe the problem, and send a photo if you have one.
02
Same-day visit where possible
We’ll give you a realistic time for getting to you, and keep to it.
03
Fixed price agreed
You have the price before we start. Quoting is free, and the figure doesn’t change afterwards.
04
Done and tidied
Job finished, tested, and the place left as clean as we found it.
Why customers come back
An honest repair or replace
If a repair will hold, that is what we’ll do. If it won’t, we’ll tell you before you spend money on a fix that won’t last.
Isolation valves as standard
Where there isn’t one, we fit one, so next time the whole house doesn’t need turning off.
Signs you may need this
- A drip that won’t stop however hard you turn it
- Handle stiff, loose or spinning
- Hot side running cold or barely running
- Green or white crust building around the base
- Water appearing under the sink when the tap runs
Common questions
Related work
Looking for taps & mixers in St Albans?
Quotes are free and fixed before any work starts, and we’ll be with you as soon as we can.